Re: shaking at mid speed. (archive)
[ Follow Ups ] [ 7-series (E32) Message Board ] [ Msg. Board FAQ ]
Posted by gale on December 31, 2001 at 10:52:53:
In Reply to: shaking at mid speed. posted by Roman on December 30, 2001 at 22:39:02:
(posted from: dialup247.nmia.com (64.42.130.62))
A trans fluid leak near the rear mounts could be the output shaft seal. Not difficult & inexpensive if you DIY but a chore to get to, but if you have the exhaust & driveshaft off anyway, it's a very simple job. Mounts are easy too.Mine was leaking & I'm sure it was from the old driveshaft imbalance loosening the output yoke flange nut. The driveshaft had been replaced at some time before I bought it but I guess they neglected to inspect the output shaft.
Your sure it's the driveshaft & not the front control arm bushings or tire balance?
gale
92 735i
150k
Follow Ups:
[ Follow Ups ] [ 7-series (E32) Message Board ] [ Msg. Board FAQ ]