Re: shaking at mid speed. (archive)
[ Follow Ups ] [ 7-series (E32) Message Board ] [ Msg. Board FAQ ]
Posted by Roman on December 31, 2001 at 16:01:07:
In Reply to: Re: shaking at mid speed. posted by gale on December 31, 2001 at 10:52:53:
(posted from: spider-we011.proxy.aol.com (205.188.195.21))
Thanks Gale, It does sounds like the oil i coming from the output. I better have my mechanic to look at it. I doubt is tire balance since I put the baby out at around 85MPh for about 20 minutes and nothing shakes. It went like new. It only does this shaking when in gear and low speed. I gonna have the mechanic change the seal, mounts and center bearing. (The mounts looks old also). You are a great help!!!!!. Thanks
A trans fluid leak near the rear mounts could be the output shaft seal. Not difficult & inexpensive if you DIY but a chore to get to, but if you have the exhaust & driveshaft off anyway, it's a very simple job. Mounts are easy too.Mine was leaking & I'm sure it was from the old driveshaft imbalance loosening the output yoke flange nut. The driveshaft had been replaced at some time before I bought it but I guess they neglected to inspect the output shaft.
Your sure it's the driveshaft & not the front control arm bushings or tire balance?
gale
92 735i
150k
Follow Ups:
[ Follow Ups ] [ 7-series (E32) Message Board ] [ Msg. Board FAQ ]