Re: Door panel help needed (archive)
[ Follow Ups ] [ 5-series (E34) Message Board ] [ Msg. Board FAQ ]
Posted by Gordon on September 02, 2000 at 18:13:55:
In Reply to: Door panel help needed posted by Steve on September 02, 2000 at 17:38:29:
(posted from: ppp28.digi-t3.st-cath.niagara.net (209.5.215.28))
Pry out power window switch, disconnect
Remove ash tray. Remove trim cover from door opening latch. Remove concealing plug from arm rest. Remove door panel retaining screws.(three...behind handle, behind ashtray,behind little cap in door pull)
unscrew door locking knob
unclip trim panel from door perimeter on clip at a time
pull top of door panel(unclip)from inside weather strip
lift trim panel up and off door. disconnect door handle release cable from handle
Note: a retaining clip behind the center of the door panel retains the anel to the door. Be sure to lift the panel up and off the clip when removingWhen reinstalling ... remove that door panel retaining piece from the metal clip in the center of the door. Install the plastic peice to the holder in the door panel, noting the installation direction
Follow Ups:
[ Follow Ups ] [ 5-series (E34) Message Board ] [ Msg. Board FAQ ]