The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
what if no self tapping screws ? (archive)

[ Follow Ups ] [ 5-series (E34) Message Board ] [ Msg. Board FAQ ]

Posted by Dragos on December 14, 2000 at 18:17:08:

In Reply to: Drill from below posted by Gordon on December 14, 2000 at 18:10:06:

Thanks Gordon !

However, I would need to remove the shelf because I want to secure it with bolts+nuts. I'm not sure self tapping screws alone will hold the weight.

If it can't be done then I'll simply forget about the bolts+nuts and get over with it..

Dragos


There is a lot of room to drill through from below... I mean, not an inch or anything, but if you mark your drill bit you should be fine. Don' t make it too complicated!





Follow Ups:



[ Follow Ups ] [ 5-series (E34) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2017 Jump Internet Inc. All rights reserved.