The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: How do I bleed coolant system????? (archive)
[ Follow Ups ] [ 5-series (E34) Message Board ] [ Msg. Board FAQ ]
Posted by Jr on March 11, 2001 at 13:17:51:

In Reply to: How do I bleed coolant system????? posted by bc on March 11, 2001 at 10:06:45:

There is an 8mm bolt at the top of the thermostat housing that when turned about a quarter turn will vent the cooling system. Turn open this bolt upon inital filling of the system until you get a steady stream of coolant. Make sure your heater controls are set to full on heat mode. After inital filling, start and warm up the motor and repeat the venting process by opening the bleed bolt and venting out trapped air. Keep repeating this process until no more air bubbles are noticed. Hope this helps.

Jr
'89 535iA





Follow Ups:


[ Follow Ups ] [ 5-series (E34) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.