The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
hmmm, but (archive)
[ Follow Ups ] [ 3-series (E36) Message Board ] [ Msg. Board FAQ ]
Posted by John 325 isT (PA) on July 30, 2001 at 06:17:48:

In Reply to: You should be hanged!!!! posted by John 325 isT (PA) on July 29, 2001 at 21:15:14:

measure the height of the audi seats relative from floor to seat height, and compare to the stock seats. If reasonably close, then check the width of the audi brackets to see if they'll fit comfy between the door sill and drive shaft tunnel. You would have to drill new holes in the floor most likely..

Be warned. Where the stock frame is bolted to the floor it is reinforced for safety.

The airbag for the passenger side will have to be looked after somehow... there is a sensor in the pass seat to know if there is someone sitting there.


Just kidding. Those are really nice seats. But you would have to custom prefab the brackets to fit. Better off getting aftermarket sparco or that other brand which escapes me at the moment. There are some awesome aftermarket seats. And they will sell brackets to make it bolt in.




Follow Ups:


[ Follow Ups ] [ 3-series (E36) Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.