The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: disconnect the odemeter (easy) (archive)

[ Follow Ups ] [ M3 Message Board ] [ Msg. Board FAQ ]

Posted by dbruce on May 12, 1999 at 20:30:30:

In Reply to: Re: disconnect the odemeter (easy) posted by powrboats on May 12, 1999 at 15:44:31:

Just something else to look for if you buy a used car.

Rip up the seat and look for wire tampering.

: : ???????????

: Ok boy's as you can see I'm not afraid to post my email. Who cares if you disconnect, fuck the next guy or the dealer your trading it into. Isn't that what this post is about?

: Here how to do it. Remove the back seat the pick up (what sends a signal) to your display (odo)is located there (wires). Carefully jack up the rear of car using a volt meter while the engine is running and wheels turning "test" the line for signal, a beeping meter is best, the faster you go the faster it beeps, that's how you know you "hit" the correct wire. Shut the vehicle off. Remove battery cable. Cut wire, put in an on/off switch hidden under seat. Now when you go in for service odo on. Any questions? Want to see photos? Email me direct and I will be happy to help you. Afterall what's better than beating the shit out of your car and selling it as a low mile garage queen to some unsupecting sap who's stupid enough to buy a used M3.




Follow Ups:



[ Follow Ups ] [ M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2017 Jump Internet Inc. All rights reserved.