The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Bentley (archive)

[ Follow Ups ] [ E36 M3 Message Board ] [ Msg. Board FAQ ]

Posted by M3Dave on January 10, 2000 at 19:38:29:

In Reply to: How to reset the check engine light on the 95 M3? posted by Jason_AZ on January 09, 2000 at 21:46:20:

On cars with OBD1,fault codes can be read by turning the ignition key on and fully depressing the accelerator pedal to the floor five times within five seconds. The check engine light will then remain on for five seconds,blink off,come on for 2.5 seconds. At this point,the fault codes will begin to flash.
If more than one fault has been detected,each code will be separated by a 2.5 second pause. When all faults codes have been displayed,there will be a .5 second flash and then the light will remain off.
To erase the fault code memory,first make sure the fault code 1000 (short blink and then the light goes out for a long period)is present,then depress the throttle fully for at least ten seconds. Read the fault codes as described earlier and check for the 1444 code (no faults stored)

get a bentley dude =)


Follow Ups:



[ Follow Ups ] [ E36 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2017 Jump Internet Inc. All rights reserved.