The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re:Enlarging transmission support brace holes (archive)

[ Follow Ups ] [ E36 M3 Message Board ] [ Msg. Board FAQ ]

Posted by Bob ///M3 on February 08, 2000 at 16:49:25:

In Reply to: Enlarging transmission support brace posted by JTTS on February 08, 2000 at 15:56:43:

Use a drill bit slightly larger then the 10mm bolt. You can also use a step type hole drill bit too. It's easy to drill. You can take a reamer bit to get rid of any rough edges if you like.

Bob ///M3

: I am wondering how do I enlarge the 8mm studs to 10mm. What bit size do you guys use or is there any other ways. Thanx.

Follow Ups:

[ Follow Ups ] [ E36 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk. Logo © 1997 - 2018 Jump Internet Inc. All rights reserved.