The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Variable throw ratio?? (archive)

[ Follow Ups ] [ E36 M3 Message Board ] [ Msg. Board FAQ ]

Posted by Michael Downs on June 24, 2000 at 13:16:44:

In Reply to: Re: Ok, I have a question, just installed UUC SS k posted by Rob @ UUC Motorwerks on June 23, 2000 at 23:32:05:

I assume that your short throw kit has a variable throw ratio that peaks out at neutral in the center between gears. This would mean that the amount of throw between the leading edge of the synchronizers is greatly reduced, but the amount of gear lever movement from when the synchronizer is first engaged to when the gear is fully seated is approximately the same as stock. If your short throw kit has a constant throw reduction throughout the travel from one gear to the next (when compared to the stock setup), then the force required to mesh the gears will go up in proportion to the amount of throw reduction.


: Too bad you're wrong, as we have discussed in the past and I will not discuss with you further.

: See the forest without the trees in the way.

: - Rob




Follow Ups:



[ Follow Ups ] [ E36 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2017 Jump Internet Inc. All rights reserved.