The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
THANKS!!! (archive)

[ Follow Ups ] [ E36 M3 Message Board ] [ Msg. Board FAQ ]

Posted by Ed on September 12, 2000 at 00:26:06:

In Reply to: Re: How to replace gauge faces>>>>>>>>> posted by Mark///97M3 on September 11, 2000 at 23:23:07:

I managed to separate the rear part of the gauge cluster but I can't figure out how to take the front clear cover off so you can reach the faces. Anyone has any idea?
THANKS!!! [email protected]

You cant take the clear face off because it glue on to the cluster.To get to the face after you separate the two piece. In piece with the needle and face their inside you will see 3 white round plastic stud that hold the face down. One in the middle top and the other two on both side. Use a needle nose and turn it till you see the part that holding the face down 360o. do that to all 3. After you do that the hold face will come out. If you need more help Email me.

Follow Ups:

[ Follow Ups ] [ E36 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk. Logo © 1997 - 2018 Jump Internet Inc. All rights reserved.