The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
solder is no good & you could have removed pin (archive)

[ Follow Ups ] [ E36 M3 Message Board ] [ Msg. Board FAQ ]

Posted by pikachu! on September 15, 2000 at 13:52:25:

In Reply to: metal butt connectors for the Ellipsoid are $$ posted by dqm3 on September 15, 2000 at 13:44:14:

i'm not sure after reading your post what you did.... you pushed the pin into the connector before you crimped on the wire, and you thought you were screwed and so went out to buy new pins and a new connector? you could have removed the pins from the connector. the pins are common AMP mfg pins and a cheap AMP pin removal tool could have take the pin out easily.

soldering... airplanes and cars do not use solder for wire harnesses - they use very good crimp connections to connect the wire to the pins. solder creates stress concentrations that are not suitable for vibration levels seen in automotive and aerospace application. go look at any of the connectors on your bmw's wire harness - none of them are soldered.


Follow Ups:



[ Follow Ups ] [ E36 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2017 Jump Internet Inc. All rights reserved.