The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
sorry about this. the best way to avoid (archive)

[ Follow Ups ] [ E36 M3 Message Board ] [ Msg. Board FAQ ]

Posted by misshift is proper technique...more on September 15, 2000 at 14:30:04:

In Reply to: my engine is totalled, help! posted by ///M3RCR on September 15, 2000 at 13:18:42:

there is absolutely nothing wrong with the factory shift set up. properly used there is no change of misshift. grip gearshift lightly as you would an egg with thumb & 2-3 fingers. do 5-4 and 4-3 downshifts and 2-3 and 4-5 upshifts with your thumb pointing down. damn near impossible to misshift this way.



hi all,

after found out my engine needed to be replaced, i am heart-broken. after 2 major mis-shifted, (2nd one was the worst, redline at 3rd, then shifted into second, ouch!) the valves are bent, and the 6th cyclinder has been chopped off into little aluminum pieces. they went into the intake manifold, and backfired to the throttle body.

to make it short, i would like to give out some advises to all your M3 owners.

1) DON'T mis-shifted
2) spend $300 for the UUC or whatever brand short shifter kit. (i am telling you NOW, it worths to install.)
3) spend another $85 for the Momo shift knob. (i can 100% guarantee you can avoid major mis-shift. since the factory shift-knob is so tall, sometimes you're just can't tell if it's fully engaged to the gear. aftermarket knobs tend to give you a clearer shift pattern.)
4) if you hear ANY rattling noise, don't drive it anymore, don't floor it and see you can tell the different of the noise. (well, i DID not do that.)

i'll post some pictures of my XXXXed up block today or tomorrow. i just hate to see a totalled block. i have never seen one or damaged one like this in my entire life. it's heart-broken.

while i am sorting out the pictures, i would like to ask for your help: please email me or response my message if you have a 3.0L US Spec M3 engine want to sell. or if you know anyone wants to sell it. i don't want the LTW version...

i am glad that i went to the M3 meeting last week, that was the last day my E36 took the last breath of its life. =~~~ i should have know there's something wrong with the car after clocked the 0-60 in 6.85sec...

thanks for reading my post, and like i said, i'll post more photos later.

regards,

Appleton
95 Silver M3c (injured)





Follow Ups:



[ Follow Ups ] [ E36 M3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2016 Jump Internet Inc. All rights reserved.