The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: question for DC.. (archive)

[ Follow Ups ] [ Z3 Message Board ] [ Msg. Board FAQ ]

Posted by DC on March 29, 1999 at 08:49:20:

In Reply to: question for DC.. posted by peterNJ on March 29, 1999 at 08:28:21:

: I'm using 2 SPL10 DVC subs (10") which require a sealed enclosure of .5-1.1 cubic feet. Can the 2 subs share the same chamber if it is 1.5 cubic feet, or should there be a separator.

***Opinions will differ but I do NOT think it is necessary to split the enclosure into two seperate enclosures. I do, however, always brace the inside of the box to avoid any flex.

: I was going to wire each sub in parallel then connect them in series to a bridged output on Rubicon502 (500W x 1 at 1 ohm) sharing the same chamber in the enclosure.

***You might even want to try a parallel/parallel set-up...the amp probably won't mind...just check it for heat.

: Any pros or cons to the set up? Can you email or post the answer.

: Thanks in advance

: peterNJ

Follow Ups:

[ Follow Ups ] [ Z3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk. Logo © 1997 - 2018 Jump Internet Inc. All rights reserved.