The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Heed step 10 and use wiggle technique (more) (archive)
[ Follow Ups ] [ Z3 Message Board ] [ Msg. Board FAQ ]
Posted by LeroyC on July 02, 2000 at 17:33:14:

In Reply to: Problems installing Jim C. Air Intake posted by Help Less in California on July 02, 2000 at 15:04:20:

When I installed mine on my M Roadster I thought it couldn't possibly fit, but it does! I've had it in and out twice and it's always hard to align, but it does go in. Just keep wiggling it around as explained in step 10 of the instructions and it will move forward enough that the mounting holes WILL align. Good luck!

: I'm haveing problems installing the Jim C. Air Intake in my 1999 MZ3 Coupe.

: The bottom hole will not line up with the bolt. They are about one and one half inches off. There is also a small gap at the front of the shield. So, logic says the thing needs to go forward more. But to looks like it cannot go any further forward. It also hits a wiring harnings harnes that is along side the raditor. I have installed the thing twice and get the same results.

: What am I doing wrong?

: Anyone got a good close up picture of one installed?

: Help Less In California



Follow Ups:


[ Follow Ups ] [ Z3 Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2010 Jump Internet Inc. All rights reserved.