|
In Reply to: Zone Adjustment posted by Harvster on July 23, 2000 at 22:49:34:
1. Turn on ignition(don't start the car)
2. Within 4 sec, press Mode button twice, then button 1. One chirp will sound. Afer 15 sec, three chirps will sound. You can now adjust interior zone.
3. Stick you hand near the center console. When your hand is sensed, it will chirp. You should get a chirp when you hand is one foot from the console but not farther. To increase sensitivity, press button 1(one chirp). To decrease, button 2(2 chirps). 4 chirps if max or min has been reached.
4. When adjusted, press mode button once, then button 1. 4 chirps . Now adjust exterior.
5. Place your head at window position. You should get a chirp here but not farther out. If not, press button one to increase sensitivity(one chirp) or button 2 to decrease(2 chirps).
6. When satisfied, turn off ignition.
7. Now arm and test to see if the zones are where you want them. If not, repeat above.
For logic sensor:
1. Turn on ignition. Within 4 sec, press button 1.
2. The siren will chirp indicating the level(1-12)
3. Press button 1 to increase the sensitivity to 8(8 Chirps)
4. Press button 2 to increase the sensitivity of the motion sensor to 8(max)
Correction on logic sensor:
Press button one to increase sensitivity
Press button two to decrease sensitivity.
For motion,
Press mode then button 1 to increase motion.
Press mode then button 2 to decrease sensitivity.
© 1997 -
2009
Jump Internet Inc. All rights reserved.
