The complete automotive resource for buyers, sellers, and owners like you.
Car, Truck and SUV Forums at Roadfly
+ Bentley Forums
+ BMW Forums
+ Cadillac Forums
+ Chevrolet Forums
+ Ferrari Forums
+ Jaguar Forums
+ Lamborghini Forums
+ Lotus Forums
+ Mercedes-Benz Forums
+ Maserati Forums
+ MINI Forums
+ Porsche Forums
+ General Discussion
+ Marketplace Forums
Re: American build quality (hood to bumper clearan (archive)
[ Follow Ups ] [ Z3 Coupe Message Board ] [ Msg. Board FAQ ]
Posted by J on May 14, 2000 at 14:36:28:

In Reply to: Re: American build quality (hood to bumper clearan posted by Dane Kane on May 14, 2000 at 13:47:52:

Great! Thanks. I'll try adjusting the rubber stops

: : Was sitting in front of my silver/black m the other day eating my tacos, chewing, enjoying the lines, when I noticed that the clearance betw the hood bottom and top of bumper wasn't quite the same left side vs right side. Left side seems tighter at about less than 1/4 inch clearance while the right side is just shy of 1/2 an inch.

: : Anyone else notice this on theirs?

: : J (1000 miles on the odometer. 200 more to go - woohoo!)

: Proper clearance is 5mm, all around....fully adjustible by rotating the four rubber stops(HOOD DETENT BUFFERS)see page 410-4/5 of your BentleyZ3 manual...all of you Msters should have one of these as almost all of the body/interior, etc.details are the same...your service/dealer guy is either stupid or lazy, lame in any case...be more assertive with them...offer to buy them a manual so they can read the spec's and no longer need to rely on myths and rumors...PS-ALSO BUMPER HEIGHT IS ADJUSTIBLE ,TOO...just in case they try to sell you that particular load of ~~~~, along with a certain bridge.....cheers! dk



Follow Ups:


[ Follow Ups ] [ Z3 Coupe Message Board ] [ Msg. Board FAQ ]
Questions, comments, or problems, please visit the Roadfly help desk.
Roadfly.com Logo © 1997 - 2009 Jump Internet Inc. All rights reserved.